Effects of yaw-roll coupling ratio on lateral-directional aerodynamic characteristics

Experimental investigation of large amplitude yaw-roll coupled oscillations was conducted in a low-speed wind tunnel using an aircraft configuration model. A special test rig was designed and constructed to provide different coupled motions from low to high angles of attack.A parameter ‘‘coupling ratio" was introduced to indicate the extent of yaw-roll coupling. At each pitch angle, seven coupling ratios were designed to study the yaw-roll coupling effects on the lateraldirectional aerodynamic characteristics systematically. At high angles of attack, the damping characteristics of yawing and rolling moments drastically varied with coupling ratios. In the coupled motions with the rotation taking place about the wind axis, the lateral-directional aerodynamic moments exhibited unsteady characteristics and were different from the ‘‘quasi-steady" results of the rotary balance tests. The calculated results of the traditional aerodynamic derivative method were also compared with the experimental data. At low and very high angles of attack, the aerodynamic derivative method was applicative. However, within a wide range of angles of attack, the calculated results of aerodynamic derivative method were inconsistent with the experimental data, due to the drastic changes of damping characteristics of lateral-directional aerodynamic moments with yaw-roll coupling ratios.     

平台式重力仪航空重力测量数据后处理技术研究

针对航空重力测量对数据后处理的要求,结合平台式重力仪系统的组成与工作原理,在重力异常信号的频域特征基础上,设计出一套有严格频域规范的航空重力数据后处理流程,并对某海域实测数据进行了处理。结果表明,重力异常值内符合精度为12条东西测线达到0.43mGal/140s和0.84mGal/100s,4条南北测线达到0.39mGal/140s和0.79mGal/100s;以同测线GT-2A单次测量结果为标准值统计标准差,12条东西测线为0.72mGal/140s和0.98mGal/100s,4条南北测线为1.41mGal/140s和1.53mGal/100s。结果表明,设计的航空重力测量数据后处理方法可以实现重力异常信号的高精度提取。     

Numerical investigation of flow mechanisms of tandem impeller inside a centrifugal compressor

This study numerically investigated a single stage centrifugal compressor ‘‘Radiver’’ with a wedge diffuser and several tandem-designed impellers to explore the flow phenomena within the tandem impeller and the potential to enhance compressor performance. The results demonstrate that tandem design and clocking fraction (λ_s) significantly affects the compressor performance. The compressor stage with tandem impellers of Series A of boundary layer growth interruption alone are observed to have a widely operating range but efficiency and total pressure ratio penalty compared with that of conventional impeller. The tandem impeller with at least the same impeller efficiency as the conventional design is considered as a critical design criteria so that further modification process based on the flow characteristic of tandem impeller is necessary. In order to restrain the inducer wake and exducer shock losses, parameters modification of blade angle and thickness distributions are necessary and the modified tandem impeller of Series B is obtained. The modified tandem impeller with 25% clocking arrangement shows an 8.45% stall margin increase and maintains the total pressure ratio and efficiency as the conventional design, which proves the potential of tandem impeller to improve compressor stage performance. It is noteworthy that the tandem impellers of Radiver have not shown obviously balanced exit flow field and the fundamental mechanism of stall margin extending of tandem impeller lies on the improved impeller/diffuser matching performance resulting from the incidence angle variation at diffuser inlet.     

变体辅助的无人机栖落机动模糊控制设计

无人机（Unmanned aerial vehicle， UAV）的栖落机动是一种大幅度的俯仰运动，易引起升降舵操纵力矩饱和。本文以变体方式增强无人机的俯仰操纵能力，并研究其对应的控制设计方法。首先对栖落机动建立了纵向动力学模型，并通过采用轨迹线性化和张量积变换方法转换得到T-S模糊模型。基于Lyapunov稳定理论和平方和方法，设计了满足控制输入约束的栖落机动多项式模糊控制器。对非变体与变体下的栖落机动控制过程进行了仿真，结果验证了控制律的有效性，并且表明变体辅助的无人机具有更强的操纵性能，能提高栖落机动中升降舵的抗饱和能力。     

L-band nighttime scintillations at the northern edge of the EIA along 95°E during the ascending half of the solar cycle 24

The characteristics of nighttime ionospheric scintillations measured at the L-band frequency of 1.575 GHz over Dibrugarh (27.5°N, 95°E, MLAT ～ 17°N, 43° dip) during the ascending half of the solar cycle 24 from 2010 to 2014 have been investigated and the results are presented in this paper. The measurement location is within or outside the zone of influence of the equatorial ionization anomaly depending on solar and geomagnetic activity. Maximum scintillation is observed in the equinoxes irrespective of solar activity with clear asymmetry between March and September. The occurrence frequency in the solstices shifts from minimum in the June solstice in low solar activity to a minimum in the December solstice in high solar activity years. A significant positive correlation of occurrence of scintillations in the June solstice with solar activity has been observed. However, earlier reports from the Indian zone (～75°E) indicate negative or no correlation of scintillation in June solstice with solar activity. Scintillations activity/occurrence in solstices indicates a clear positive correlation with Es recorded simultaneously by a collocated Ionosonde. In equinoxes, maximum scintillations occur in the pre-midnight hours while in solstices the occurrence frequency peaks just after sunset. The incidence of strong scintillations (S₄ ≥ 0.4) increases with increase in solar activity. Strong (S₄ ≥ 0.4) ionospheric scintillations accompanied by TEC depletions in the pre-midnight period is attributed to equatorial irregularities whereas the dusk period scintillations are related to the sporadic-E activity. Present results thus indicate that the current location at the northern edge of the EIA behaves as low as well as mid-latitude location.     

基于LSTMAttention网络的短期风电功率预测

提出一种基于LSTMAttention网络的短期风电功率预测方法。首先,使用LSTM网络对数值天气预测(NWP)数据的特征信息进行提取,同时采用注意力机制有效分析了模型输入与输出的相关性,从而获取了更多重要时间的整体特征；其次,使用卷积神经网络(CNN)提取NWP数据的局部特征,并引入压缩和奖惩网络(SE)模块学习特征权重,利用特征重新标定方式提高网络表示能力；最后,将局部特征和整体特征进行特征融合,通过分类器输出分类结果。利用NOAA提供的美国加利福尼亚州某风电场的数据进行案例分析,证明了所提方法的有效性。试验结果表明,与BP神经网络、自回归积分滑动平均模型(ARIMA)模型和LSTM模型相比,LSTMAttention模型具有更高的预测精度,证明了该方法的有效性。     

Thrusting maneuver control of a small spacecraft via only gimbaled-thruster scheme

The thrust vector control (TVC) scheme is a powerful method in spacecraft attitude control. Since the control of a small spacecraft is being studied here, a solid rocket motor (SRM) should be used instead of a liquid propellant motor. Among the TVC methods, gimbaled-TVC as an efficient method is employed in this paper. The spacecraft structure is composed of a body and a gimbaled-SRM where common attitude control systems such as reaction control system (RCS) and spin-stabilization are not presented. A nonlinear two-body model is considered for the characterization of the gimbaled-thruster spacecraft where, the only control input is provided by a gimbal actuator. The attitude of the spacecraft is affected by a large exogenous disturbance torque which is generated by a thrust vector misalignment from the center of mass (C.M). A linear control law is designed to stabilize the spacecraft attitude while rejecting the mentioned disturbance torque. A semi-analytical formulation of the region of attraction (RoA) is developed to ensure the local stability and fast convergence of the nonlinear closed-loop system. Simulation results of the 3D maneuvers are included to show the applicability of this method for use in a small spacecraft.     

Analytical Calculation Model for Mach Wave Parameters

When a wave shaper is embedded in a liner,Mach wave will emerge above the liner,which affects the head shape of an explosively formed projectile.Mach wave parameters,including radius and pressure need to be determined to effectively match Mach wave with the liner,so that a good head shape can be obtained.An analytical calculation model for Mach wave parameter is presented based on three-shock theory,and the theoretical values agree well with the experimental ones.The analysis shows that when the radius of the wave shaper is constant,the radius of the Mach wave increases,whereas the pressure decreases while increasing the distance between the liner and the wave shaper.When the distance between the liner and the wave shaper is constant,the radius of the Mach wave increases,whereas the pressure decreases when decreasing the radius of the wave shaper.     

直升机抛射物体平衡及稳定性分析

基于部件级建模理论建立了建立直升机-外挂装置系统六自由度飞行动力学模型。对所建模型进行了配平计算，与参考数据进行了对比。计算分析了不同速度下采用不同方式抛射物体时直升机的稳定性。结果表明，单侧抛射由于反冲力不对称，抛射物体对于直升机的滚转角和横向周期变距有显著的影响；随飞行速度增大，抛射物体对于直升机横向荷兰滚模态稳定性影响增大，当前飞速度达到50m/s以上时，荷兰滚模态演变为两个发散的非周期模态，稳定性明显变差，直升机应在较低速度下抛射物体。      

运输机机翼平面参数快速优化方法

提出了一套机翼平面参数快速优化方法。新方法通过改变优化思路,简化计算模型,合理选择计算方法,有效地提高了优化效率。简要介绍参数优化思想与流程控制,重点阐述优化程序的气动、重量与性能计算模块的算法。以某运输机为算例,优化结果与资料数据吻合,验证了新方法的正确性。